NA2480 Series Retainer Nut / 3D0364 / NAS1794

RetainerNutRivetlessComposite Application Notes: *UNLESS OTHERWISE SPECIFIED* This drawing takes precedence over all documents referenced herein.Dimensional tolerances and symbols per ANSI Y14.5M-1982.Surface texture 125 microinches Ra max per ANSI B46.1-1978.Deburr and break all edges .005-.015./5/ Diameter “A” is not inspectable at receiving. This is the final hole diameter after installation without reaming./6/ “L” is not inspectable […]

Read More…

NA2475 Series Retainer Nut / 3D0280 / NAS1794

RetainerNut RivetlessClass III Fit Notes: *UNLESS OTHERWISE SPECIFIED* This drawing takes precedence over all documents referenced herein.Dimensional tolerances and symbols per ANSI Y14.5M-82.Surface texture 125 microinches Ra max per ANSI B46.1-78.Deburr and break all edges .005 – .015./5/ These retainers shall meet the minimum torque-out and push-out requirements as specified in MIL-N-25027 except nut retainers […]

Read More…

NA2474 Series Retainer Nut / 3D0279 / NAS1794

RetainerNutRivetlessClass III Fit Notes: *UNLESS OTHERWISE SPECIFIED* This drawing takes precedence over all documents referenced herein.Dimensional tolerances and symbols per ANSI Y14.5M-82.Surface texture 125 microinches Ra max per ANSI B46.1-78.Deburr and break all edges .005 – .015./5/ These retainers shall meet the minimum torque-out and push-out requirements as specified in MIL-N-25027 except nut retainers shall […]

Read More…

NA2473 Series Retainer Nut / 3D0271 / NAS1794

RetainerNutRivetless Class III Fit Notes: *UNLESS OTHERWISE SPECIFIED* This drawing takes precedence over all documents referenced herein.Dimensional tolerances and symbols per ANSI Y14.5M-82.Surface texture 125 microinches Ra max per ANSI B46.1-78.Deburr and break all edges .005 – .015./5/ These retainers shall meet the minimum torque-out and push-out requirements as specified in MIL-N-25027 except nut retainers […]

Read More…